Enable discrete values in Numeric Slicer

The new Numeric Slicer is a great addition, but there is a small issue with it that I'd like to see addressed if possible.

I have set up a table with discrete values which I am using as a basis for the slicer. In this particular case, it's a table of percentages from 0 to 0.02 in 0.0001 increments, but it could be anything really. The issue is that when moving the slider, the values that it selects are not ones in the table. So for example, selecting between 0.005 and 0.01 using the slider actually uses the values 0.00497598796 and 0.0100467686 behind the scenes. This usually works in that it gives the correct range of values, however it sometimes approximates in the wrong direction, thus missing out a value.

The worst case is when you drag the two ends of the slider together to select a single value. So selecting 0.01 should allow that value to be shown, as it is in the table, but in fact the slicer selects all values between 0.0100467686 and 0.0100467686 which means it actually selects nothing.

To me as a user, this seems illogical, although I can understand the workings behind it. So can the slicer be modified in some way to allow the selection of discrete values only?